Instruction Manual for Warmpi Heating Pads
To achieve the best results and ensure safety, we recommend that you read this instruction manual carefully before using the heating pad
This is how Warmpi works optimally:
The heat pad works at its best when it needs to transfer heat directly to your body.
Sit comfortably against the heat pad and after 5 minutes you will notice the temperature increase significantly.
Warmpi has 3 heat settings:
- RED, the highest setting, with a temperature up to 50°C
- WHITE, the middle setting, with a temperature up to 40°C
- BLUE, the lowest setting, with a temperature up to 30°C
It usually takes about 60 seconds until the heat pad becomes perceptibly warm, and in 5-10 minutes the pad has reached its working temperature. The duration may vary depending on the model and type of fabric.
Instructions
Connecting and turning on
- Plug the heat pad into an electrical outlet or USB port/power bank.
- Press and hold the ON/OFF button for 2 seconds to turn the pillow on.
- The ON/OFF button will now flash RED and the pillow will remain in this warmest setting for 5 minutes.
- After 5 minutes, the pillow will automatically switch to the middle temperature setting and remain in this position.
- Turn the pillow off by pressing the ON/OFF button for 2 seconds. The light of the button will now turn off.
- Unplug Warmpi from the power source.
Prefer to immediately enjoy the maximum setting for a long time?
- Turn the pillow on (by holding the ON/OFF button for 2 seconds).
- Then press the button 3 more times and go past the middle WHITE and lowest BLUE setting to turn on the maximum RED setting continuously.
- The button now burns RED continuously and the pillow will now emit maximum heat continuously.
- When you are done, turn the pillow off by again pressing the ON/OFF button for 2 seconds (until the light is off).
- Unplug the pillow from the power source.
–Extra info for using your own powerbank–
Most mobile powerbanks have an USB output of +/- 5 volts and 2.0-2.5 amps (in most cases this is written on the powerbank).
5V is exact the amount of power your Warmpi needs so this is ideal for use with your warmin pillow.
The number of amps (amp) is in this case not so important, this is applicable for example for fast charging functions for cell phones.
The power bank can be placed outside the pillow, or at the back between the cover and the filling cushion. At this moment there is no special compartment in the cushion to put powerbank. In the future, Warmpi will also be available with his own 10,000mAh power bank.
How long will Warmpi work with your powerbank?
With a 10000mah powerbank you can enjoy about 4 hours of optimal heat in the maximum temperature setting (RED).
The middle setting (WHITE) works easily over 8 hours on a full 10000mah powerbank.
Not sure if your powerbank is compatible with your heat pad? Please contact us via chat or klantenservice@warmpi.nl.
Maintenance and Cleaning
Clean the surface of the heat pad with a damp cloth. The button is water resistant, this does not apply to the connectors on the back of the button. Make sure the cushion is completely turned off and disconnected before you begin cleaning.
Warnings:
- Do not use the heat pad if the wiring is damaged.
- Supervise the heat pad when it is used by children or persons with limited mobility.
- Do not leave the heat pad on when absent.
- Always place the heat pad in a dry place and make sure the cable remains undamaged.
- Make sure the heat pad has cooled down before storing it.
Always follow the specific instructions and warnings if provided with the heat pad, and use it in a safe and responsible manner. If you experience unusual problems or malfunctions, contact customer service at klantenservice@warmpi.nl.